Stainless steel delta ring with 4 flat hooks, 10 000 daN ultimate load. Central gathering point for lifting net assemblies. One captive hook to prevent loss of parts.
Data sheet
The lifting ring is a stainless steel delta ring fitted with 4 flat hooks, used as the central gathering point of a lifting net assembly. Each hook is sewn to one corner of the lifting net, and the four straps converge on the delta ring to form the lifting attachment for the crane or hoist. One of the four hooks is captive on the ring, which prevents loss of a part during handling and storage.
Ultimate load is 10 000 daN. Construction is stainless steel for corrosion resistance, with a 130 mm ring and a total weight of 2 270 g.
Stocked as a spare part. Selection of lifting and load-bearing assemblies must follow the applicable rating and inspection requirements for the intended use.
16 other products in the same category:
Cam buckles are simple manual tensioning devices for restraint straps. The cam locks the webbing as soon as the lever is released, giving reliable load securing without the bulk or effort of a...
Belt buckles supply a quick connection for light belt and restraint assemblies, with male and female parts forming the complete buckle. They are used for equipment belts, light cabin restraints and...
This hook combines a fixed eye for permanent attachment with a hooking end fitted with a safety latch. The eye is sewn or pinned to the net edge, and the latched hook engages cabin anchor rings,...
This end fitting carries a latched hook mounted on a triangular delta ring, the delta ring taking the 50 mm webbing and the latched hook engaging on anchor rings, floor fittings and other...
Fixation plates are flat anchor parts used to bolt the end of a webbing strap to the airframe, a load platform or any structure with matching threaded holes. The webbing loops through the plate,...
Raschel netting is a knitted mesh fabric supplied by the metre and used to build cabin partitions, baggage retention curtains and custom net assemblies that need a textile mesh rather than a...
This hook-and-loop fastener system is the aerospace counterpart of standard Velcro tape, used in cabin assemblies where a removable fixture is required and where a fire-retardant textile is...
This tubular polyester webbing is used for corner ropes and lashing assemblies in air transport. The tubular construction spreads the load around the full circumference of the strap, which limits...
The threaded studs with nut connect equipment, seats and accessory rails to the seat track or to an air cargo pallet attachment, with a standard hex nut that is torqued with a wrench. They are the...
Round rings are closed anchor parts used as connection points in restraint, tie-down and lifting assemblies. The closed shape lets straps, slings and connectors run all the way around the ring,...
Quick links are reusable connectors with a screw-gate closure: a threaded sleeve runs along the gate to lock the link closed once a strap or ring is engaged. They replace permanent shackles where a...
This aluminium double anchor plate provides a reinforced attachment point for stud fittings in cargo restraint assemblies that call for a higher load rating than the standard anchor plate. It...
This PVC tarpaulin is the fire-resistant grade specified for use in aircraft cabins and air cargo holds, where any covering material must meet flammability requirements. It is used for load...
Double stud fittings engage two adjacent positions of a seat track or air cargo pallet rail, giving a stronger anchor point than a single stud. They are the standard anchor format for ULD restraint...
Ratchet buckles are manual tensioning devices for restraint and lashing straps. The ratchet mechanism applies and holds high tension in controlled increments, which makes it the standard choice for...
D-rings are half-round anchor parts used as fixed attachment points for restraint strap and net assemblies. The flat side takes the webbing loop and the round side receives the hook, snap or...
Stainless steel delta ring with 4 flat hooks, 10 000 daN ultimate load. Central gathering point for lifting net assemblies. One captive hook to prevent loss of parts.
